13
M2x10mm
Repeat this procedure to mount the servo in
the other panel.
INSTALLING VERTICAL STABILIZER
2) Use a ruler and carefully cut the cover-
ing inside the line drawn on the stabilizer
to remove the covering. Use care not to
cut into the underlying wood, weakening
the stabilizer.
1) Check all alignments. Mark the out-
line of the fuselage on vertical stabilizer.
Pen
3) Slide the vertical stabilizer back in-
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90º.
Remove covering.
4) When you are sure that everything is
aligned correctly, mix up a generous
amount of Flash 30 Minute Epoxy. Set
the stabilizer in place and realign. Dou-
ble check all of your measurements
once more before the epoxy cures.
RUDDER PUSHROD INSTALLATION.
Repeat steps as same as steps done for
aileron.
90
0
90
0
