Seagull Models NIEUPORT 28 REPLICA, Assembly Manual

Page: 40 / 45

NIEUPORT 28 REPLICA
Instruction Manual.
40
1
.
3 .
2)Attach the clevis to the brass tab next to
the rear interplane strut on the upper-
lower wing.Slide a copper crimp on the
cable. Pass the cable through the brass tab
on the upper wing, the back through the
copper crimp.
Begin placing tension on the wires,
working from the ends that have been
crimped to the ends that have not. Thre
should be light tension on all the cables,
but not enough to change the position
of the wing. Once the cables have been
tensioned, begin by securing the crimps
where the cables pass through the tabs
near the fuselage. Thn secure the crimps
at the cable ends. Once tensioned, use
side cutters to trim the excess cable.
1) Locate the wing transport frams and
rubber bands. Slide the frames between
the top and the bottom wing as shown.
Use a rubber band to hold the frame to
the top and bottom wing.
REMOVING THE WING PANELS.
4 .
5
.
2
.
1
.