Seagull Models NIEUPORT 28 REPLICA, Assembly Manual

Page: 18 / 45

NIEUPORT 28 REPLICA
Instruction Manual.
18
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at
the trailing edge, and place a mark. Use a
triangle and extend this mark, from back
to front, across the top of the stabilizer.
Also extend this mark down the back of
the trailing edge of the stabilizer.
ElevatorFiberglass control horn.
2 .
3 .
4) With the stabilizer held firmly in place,
use a pen and draw lines onto the stabilizer
where it and the fuselage sides meet. Do this
on both the right and left sides and top and
bottom of the stabilizer.
2) Using a modeling knife, carefully
rmove the covering at mounting slot of
horizontal stabilizer (both side of fuse-
lage).
3) Slide the stabilizer into place in the
precut slot in the rear of the fuselage. The
stabilizer should be pushed firmly against
the front of the slot.
1
.
2
.
3 .
Epoxy.
Epoxy.
Draw center line.
Cut.
INSTALL ELEVATOR CONTROL HORN.
Fiberglass control horn.
1
.