DUAL ACE.
Instruction Manual.
16
Installing the hard wood block.
Pushrod wire
Slide one 60mm diameter wheel collar
onto the axle and tighten. Slide the nose
wheel on and push it up against the wheel
collar. Slide the remaining wheel collar on
and push it up against the wheel and tighten
the set screw. The wheels should spin free
and not bind in any way.
Adjust the nose gear steering arm until the
arm is parallel with the fire wall.
Install the pushrod wire as shown.
Installing steering arm as below.
Steering arm.
Adjustable connector.
!
2) Slide one 60mm diameter wheel onto
each axle and push them up against the wheel
collars. Slide the remaining wheel collars with
3mm x 6mm set screws onto the axles. Push
them up against the wheels and tighten the
set screws. The wheels should spin free and
not bind in any way. If they do bind, loosen the
set screws in the outer wheel collars and move
the collars out a small amount. Retighten the
set screws.
Repeat the procedure for the other
main gear wheel.
PARTS REQUIRED
NOSE GEAR INSTALLATION.
{1} Nose gear.
{1} Steering arm.
{1} Connector.
{1} Wheel.
{2} Collar.
C/A glue.
Adjustable
connector.
INSTALLING THE MAIN GEAR WHEELS.
!
1) Slide one wheel collar with 3mm x
6mm set screw onto each axle. Push the
wheel collars on as far as they will go and
tighten the set screws.
Be careful not to overtighten the set
screws. Overtightening may cause the
threads to strip.
INSTALLING THE NOSE GEAR
WHEEL.
