DUAL ACE.
Instruction Manual.
15
Remove covering.
Mounting slot.
!
1) Using a modeling knife, remove the cov-
ering from over the two main gear mounting
slots located in the bottom of the wing. One
slot is located in each wing half.
!
2) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
MAIN LANDING GEAR
INSTALLATION.
!
3) The landing gear wire is held in place
using two nylon landing gear straps and four
3mm x 10mm wood screws.
NOTE
:
!
4) Using the two landing gear straps as a
guide, mark the locations of the four 3mm x
10mm mounting screws onto the wing sur-
face.
!
5) Remove the two straps and the gear
wire. Drill four 1mm pilot holes into the wing
for the wood screws.
Be careful not to drill through the top
of the wing!
INSTALLING THE MAIN GEAR WIRES.
Repeat the procedure for the other
main gear wire.
Pen.
3mm X 10mm.
3 x 10mm.
The straps should be located equal
distance from the inside and outside
ends of the wire.
Landing gear wire.
