DUAL ACE.
Instruction Manual.
17
HORIZONTAL STABILIZER.
!
2)Using a modeling knife, carefully remove
the covering at mounting slot of horizontal sta-
bilizer ( both side of fuselage).
!
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
!
3) Slide the stabilizer into place in the pre-
cut slot in the rear of the fuselage. The stabi-
lizer should be pushed firmly against the front
of the slot.
Remove covering.
INSTALLING THE COWLING.
Slide the fiberglass cowl over the engine
and line up the back edge of the cowl with the
marks you made on the fuselage then trim and
cut.
Correct the cow at right possition then se-
cure it in place using four 3mm x 10mm wood
screws. See picture below.
3mm X 10mm(4pcs).
3mm X 10mm.
Center line.
