Seagull Models CURTISS P-40N WARHAWK, Assembly Manual

Page: 23 / 28

WWW.SEAGULLMODELS.COM
23
2) A scale pilot is included with this ARF.
The Seagull Pilot included fitting well to
the cockpit. (or you can order others scale
pilot figures made by Seagull factory.
They are available at Seagull distributors.)
If you are going to install a pilot figure,
please use a sanding bar to sand the base
of the figure so that it is flat.
3) Position the pilot figure on the can-
opy floor as shown. Use epoxy to glue
the base of the pilot figure to the cockpit
floor, please see pictures as shown.
Epoxy.
260mm
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the fu-
selage using a felt-tipped pen. Carefully
cut and remove covering material from
the fuselage where the canopy makes
contact, exposing the bare wood. Then
permanently glue the canopy in place
with epoxy glue or special “canopy glue”.
Epoxy.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
INSTALLING BATTERY - RECEIVER.
1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and aid
in their location.
APPLY THE DECALS.
Receiver.
Battery.
Battery.