92
Product Manual - Disc Drive SCSI-2/SCSI-3 Interface (Vol. 2; Ver. 2), Rev. E
_____________________________________________________________________________________
Table 5.1.1-10h. Jumper Settings Page (Page C2h)
Bit
7
6
5
4
3
2
1
0
Byte(s)
0
Peripheral Qualifier [1]
Peripheral Device Type
[1]
1
Page Code (C2h)
[2]
2
0
0
0
0
0
0
0
0
3
Page Length (02h)
[3]
4
DS [4]
MS [5]
WP [6]
PE [7]
DRIVE ID [8]
5
Rsvd
Rsvd
Rsvd
Rsvd
Rsvd
Rsvd
Rsvd
Term
Enable
[9] [10]
Notes.
[1] The Peripheral Qualifier and Peripheral Device Type are as defined previously. (See Table 5.1.1-8 notes).
[2] Page C2h provides all the jumper settings for the drive. The bits in byte 4 indicate which jumpers are on.
[3] The Page Length field specifies the length of the Jumper Setting Page. If the allocation length is too small
to transfer all of the page, the page length shall not be adjusted to reflect the truncation.
[4] Delayed Motor Start (DS) bit when set to 1 indicates that this jumper is on.
[5] Motor Start (MS) bit when set to 1 indicates that the jumper is on.
[6] Write Protected (WP) bit when set to 1 indicates that the write protect jumper is on.
[7] Parity Enable (PE) bit when set to 1 indicates that SCSI parity error checking jumper is on.
