Seagate OneStor SP-3584, Installation & User Manual

Page: 61 / 78

Module Replacement
53
2
Slide the PSU into its slot until the latch clicks home. The enclosure will automatically detect the new
unit.
6.6 Replacing an SBB I/O Module
Important Before removing an SBB I/O module, make sure you have a replacement module to insert.
Note A variety of I/O modules can be used in the enclosure. These procedures show a

12Gb/s SAS EBOD I/O module.
6.6.1 Removing an SBB I/O Module
1
Identify the SBB I/O module to be removed. If the module has failed, the fault LED will be lit amber
(see
Figure 6–13 ).
2 Make a note of the locations of the cables before removing them from the I/O module.
3
As shown in Figure 6–14 and Figure 6–15 , pinch the latch on the module and pull the handle towards
you (1). This will lever the module out of its connector on the midplane.
4 Pull the module out of the enclosure (2).
Figure 6–13 SBB I/O Module LEDs (12Gb/s SAS EBOD module shown)