Installation
Chapter 3
Product Description Manual
Page 23
Pin
Assignment
Description
Source
30
GND
Ground
N/A
31
INTRQ
Interrupt Request
Device
32
10CS16-
16-Bit I/O
Device
33
DA1
Device Address Bit 1
Host
34
PDIAG
Passed Diagnostics
Device
35
DA0
Device Address Bit 0
Host
36
DA2
Device Address Bit 2
Host
37
CS0-
Chip Select 0
Host
38
CD1-
Chip Select 1
Host
39
DASP-
Device Active or Slave
Present
Device
40
Ground
Ground
N/A
10. Replace the computer cover. Be sure to reconnect any peripherals that you
disconnected during the installation.
11. Plug the computer and any peripherals into an AC power outlet.
Custom Installation with the Seagate IDE Adapter Card
The Seagate IDE Adapter card and the Seagate Backup software is set at the
factory to IRQ level 15 and I/O address 170h. Depending on the configuration
of your system—including the type of peripherals and the motherboard, a
custom installation will be necessary if a conflict exists with the factory default
settings of the adapter card and the software.
This section describes the steps to take to set up the correct IRQ and address
settings if a conflict occurs.
1.
Run the DOS (Version 5.0 or above) program MSD.EXE by typing MSD at
the DOS prompt.
If you do not have DOS Version 5.0 or higher available on your computer,
go to Step 3.
Once MSD completes, a screen is displayed showing the options of the MSD
program.
2.
Select the IRQ button to display the use of interrupts for your computer.
The interrupts are listed 0 through 15. Some of the IRQ settings are shown
as reserved.
If IRQ 15 is used for a device other than the IDE Adapter card, refer to the
settings list in Step 3 and set the adapter card to correspond to an available
IRQ level.
Summary of Contents for 10002475-003
