SD-MA-025
24
4.4.5
Set IP info via network
After connecting to the device via network we can query information as follows
.
Step A
: Switch to ‘Network Setting’ page, then click the ‘Search Device’ button to search devices
Step B:
Click the device you want to configure in the result list (When you click it, the software will read
the network configuration of the device automatically)
Step C
：
Modify the IP address or the IP address type or other configuration.
Step D
: Click the ‘Save Config’ button to save data
Step E
: When the software shows a message of ‘
Succeeded
’, click ‘Search Device’ button to load
configuration again to make sure your modification is saved successfully.
NOTE
：
1.
When selecting the device, it will display the matrix’s network board information. User can edit the
device’s name, in order to better identify matrix. User can set dynamic IP/ static IP, subnet mask,
gateway and another network information. At the same time, user can also set the device port.
Serial port baud rate is 9600 (the user cannot change the baud rate, otherwise it will lead to the
network control failed).
2.
Configuration via UART only support modify IP address or IP address type. If you want to modify
another configuration, please configure it via Network
