Seabreeze PTAC09CH3ZX, Installation And Operation Manual

Page: 15 / 27

950-0094-revA - 15 - 26 February, 2008
Height:
Fits 2 courses concrete block
Fits 6 courses standard brick
Fits 5 courses Jumbo Brick
Width: fits approximately 3 stud spaces.
If field supplied case angles must be used during installation (Fig 5), proceed as
follows:
•
Position the case angles around top and sides of sleeve to get the proper
depth, (be sure to have the angles pointing outside).
•
Mark the sleeve using the case angles as a template for screws.
•
Drill 5/32” hole at the marked position.
•
Install # 10 x ½” screws from the outside of the sleeve, do not drill any holes in
the base of the sleeve.
4. Installation of the sleeve in the wall opening
•
Place sleeve into the wall, refer to Chart 1-D2 for room side projection
(minimum ½” to a maximum 1-3/4” without sub-base). The rear (outside edge of
the sleeve should stick out a min. of ¼” past the outside wall to be able to
caulk properly. Do not seal the drain holes on the outside (grille side) of the
sleeve. If it is desired to have the rear grille flush on the outside, a drip rail