E-12
1
2
3
4
6
This model can be powered by the following batteries.
Use two of each type.
Make sure that the mode switch is
in the OFF position
Turn the battery cap counterclockwise
and remove (Fig.1)
●
Take care to insert the batteries in the
correct direction.
Apply silicon grease to the O-ring
●
Check the O-ring to make sure there are
no scratches or debris, and apply a light
coating of the included silicon grease.
After closing the battery cap completely,
turn back the cap to align the concave
marks (Fig.4)
5
Align the
▲
mark inside the battery
cap with the
▼
mark (salient) on the
battery compartment (Fig.3), and turn
the cap clockwise to close
CAUTION
●
When installing or removing batteries, thoroughly wipe water off the
strobe and dry your hands. Pay particular attention not to allow water
from your hair or wetsuit to drip into the battery compartment. This is
in order to prevent an electrical hazard, mold, malfunction or flooding.
●
Never mix old and new batteries or batteries of different types.
●
Always replace all batteries with new batteries at the same time.
Installing the Batteries
AA alkaline battery
、
AA Ni-MH battery
、
AA oxyride battery
Insert two batteries aligned to the
+ and - marks (Fig.2)
Fig.1
Fig.2
Fig.3
Fig.4
