SEA USER 2 24V DG R1B ALL-IN, Manual, Page: 33 / 40

Ad ices
Make sure all Safeties are turned ON
Problem Found Possible Cause Solutions
FAILURE 24VAUX
a) Overload or short-circuit on the output N°10
b) Burnt fuse a) Check a short circuit on the cable
b) Change fuse
Control board powers up, but
motor does not run
a) Stop button active or jumper not in place for
stop circuit
b) Open or Close Input active
c) Entrapment Protection Device active
d) Defective control board
a) Check Stop button is not "stuck on"", or verify that the stop
button is a normally closed circuit, or put a jumper on the stop
circuit
b) Check all Open and Close Inputs for a "stuck on" Input
c) Check all Entrapment Protection Device inputs for a "stuck
on" sensor
d) Replace defective control board
Solar operator not getting
enough cycles per day
a) Insufficient panel wattage
b) Excessive accessory power draw
c) Old batteries
d) Solar panels are not getting enough sunlight
a) Add more solar panels
b) Reduce the accessory power by using low power accessories
or set the 24Vaux only in cycle
c) Replace batteries
d) Relocate the solar panels away from obstructions (trees,
buildings, etc.)
Solar operator insufficient
stand-by time
a) Insufficient panel wattage
b) Excessive accessory power draw
c) Battery capacity too low
a) Add more solar panels
b) Reduce the accessory power draw by using low power
accessories
c) Use batteries with higher amp hour (Ah) rating
taliano
ENGLIS
International registered trademark n. 804888
TO THE ATTENTION OF BOTH INSTALLER AND END USER
MAIN ENAN E
Periodicall , based on the number of maneuvers performed over time and based on the t pe of operator, if
a change in friction, malfunctioning or non-compliance with the previousl set times are noticed,
it o ld
e ad isa le to repro ram t e learnin times on t e control nit
Periodicall clean the optical s stems of the photocells
RE LA EMEN S
An request for spare parts must be sent to: p Teramo T seateam com
SA E AND ENVIR NMEN AL M A I ILI
Disposal of pac aging materials and/or circuits should ta e place in an approved disposal facilit
REGULAR R DU DIS SAL electric and electronic aste
(It s applicable in EU countries and in those ones provided with a differential waste collection)
This brand on the product or on documentation indicates that the product must not be disposed off together
with other domestic waste at the end of its life c cle. In order to avoid an possible environmental or health
damage caused b irregular waste disposal, we recommand to separate this product from other t pes of
waste and to rec cle it in a responsible wa in order to provide the sustainable re-use of material resources.
Domestic users are invited to contact the retailer where the product has been purchased or the local office
to get all the information related to differential watse collection and rec cling of this ind of product
IMMAGA INAMEN
Materials handling must be made with appropriate vehicles
ARRAN LIMI S - see the sales conditions
SEA S.p.A. reserves the right to ma e any required modification or change to the products and/or to this
manual without any advanced notice obligation
T
min
T
Max
Dampness
min
Dampness
Max
- 20°C + 65°C
5%
not condensing
90%
not condensing
ARE USING EM ERA URES
64