SAFETY PRECAUTIONS
Every change on trimmers and on dip switch must be done with the gate closed, or without
power supply.
All electrical installation work should conform to the current edition of the LEE Regulations
and all electrical work should only be carried out by a competent electrician. A 16A - 0,03A
differential switch must be incorporated into the mains electrical supply of the gates. Earth
bonding of the entire gate system must be correctly carried out.
To prevent mains interference all low voltage cabling (Push button, Photocell, Radio etc.)
should be run in separate cable ducts from main carrying cables.
Note: Use “cable clips” and/or “duct/box pipes” fitting close to the control panel box so to
protect the interconnection cables against pulling efforts.
SPARE PARTS
To obtain spare parts contact:
Tel.:
++1-305.594.1151 - Fax: ++1-305.594.7325 - Toll Free: 800.689.4716
e-mail: [email protected]
INTENDED USE
The USER 2 24V electronic control unit has been designed to be solely used as control unit
for the automation of sliding gates.
LIMIT OF GUARANTEE
The USER 2 24V electronic control unit is guaranteed for a period of 24 months. The
guarantee period starts from the date stamp printed on the unit. The USER 2 24V guarantee
will be void if the unit has been incorrectly installed, not used for the intended purpose,
tampered with or modified in any way. The validity of this guarantee only extends to the
original purchaser of the unit.
NOTE: THE MANUFACTURER CAN NOT BE DEEMED RESPONSIBLE FOR ANY
DAMAGE OR INJURY CAUSED BY IMPROPER USE OF THIS PRODUCT.
SEA USA Inc.
10850 N.W. 21st unit 160 DORAL MIAMI Florida (FL) 33172 USA
67410925
20
USER 2 - 24V
International registered trademark n. 2.777.971
REV 02 - 06/2010
