Coastal 14 Ku-Band TVRO
Installation
1-5
7.
Lift the base of the radome up and connect
the antenna cable to the base of the antenna.
8.
While being careful not to pinch or kink the
antenna cable, set the radome base mounting
bolts into the mounting holes.
9.
From the underside of the mounting surface,
install a ¼” flat washer, a small pattern
washer and a nylon lock nut on each of the
mounting bolts.
10.
Tighten all four of the nuts.
11.
Re-install the radome top.
1.9.
Install the Antenna Control Panel
Refer to the Installation Arrangement drawing.
1.
Assure that the DC Power Cable is not
connected to the DC Supply.
2.
At the antenna control panel, connect the red
wire to the + (plus) terminal on the green
screw terminal.
3.
Connect the black wire to the - (minus)
terminal on the green screw terminal.
Summary of Contents for Coastal 14
