Sea Tel Coastal 14, Installation And Maintenance Manual

Page: 10 / 47

Installation Coastal 14 Ku-Band TVRO
1-6
4. Connect the antenna cable to the IN
connector of the antenna control panel. This
IN connection supplies 30VDC operating
voltage and antenna control signals to the
antenna and receives satellite signal from the
antenna.
CAUTION: Connecting the satellite receiver to the
IN connector may damage the satellite receiver.
5. Connect the receiver cable to the OUT
connector of the antenna control panel.
CAUTION: Connecting the satellite receiver to the
IN connector may damage the satellite receiver.
6. Install the antenna control panel into the
cutout and secure with self tapping screws
7. At the DC Power Supply, connect the red
wire to the plus voltage output terminal.
Connect the black wire to the minus (or
ground) output terminal.
1.10. Install the Satellite Receiver and Television Set
Connect the receiver cable from the antenna control panel’s RF “Out” Port to the satellite input
connection on the rear of your receiver.
Connect desired configuration of audio/video cables between the satellite receiver and television set (or
monitor & stereo equipment).