Coastal 14 Ku-Band TVRO
Setup
2-1
2.
Setup
2.1.
System Checkout
1.
Press the ON key on the antenna control panel. Both LED’s (TRACKING and UNWRAP) should
illuminate for 5 seconds verifying the DC power and LED cable connections between the
antenna control panel and the antenna pedestal assembly.
2.
Turn power ON to the satellite receiver and the TV monitor. The television may now be
displaying “searching for satellite signal” verifying proper video connections between the
receiver and the monitor.
2.2.
Initial Factory Setup
Your system comes from the factory preprogrammed for the following satellites:
SAT1 DTV 101 W DirecTV 101 W
SAT2 DTV 110.1 W DirecTV 110 W with 110 HD converter ON
SAT3 DTV 119 W DirecTV 119 W
SAT4 Dsh 110 W Dish Network 110 W
SAT5 Dsh 119 W Dish Network 119 W
SAT6 Dsh 148 W Dish Network 148 W
If you want to change this programming refer to the paragraphs below.
2.3.
Changing the Initial Factory Setup
If you want to change the order of the initial setup of satellites, remove unused satellites or add/replace
with new satellites then refer to the paragraphs below.
Press and hold
SAVE
+
▼
for 6 seconds to access SETUP Mode. “Setup Mode” will be displayed on
the first line of the display while the panel is in SETUP Mode.
Use the
▼
&
▲
arrow keys to scroll down & up through the Setup parameters listed below.
NOTE:
You will save individual set-up parameter settings as you modify them in the
procedure below (quick presses of the SAVE key). These will only save the settings until
POWER is cycled to the antenna.
When you are finished making all of your desired changes, you
MUST press and hold the
SAVE key for six seconds, “Settings Saved” will be displayed.
Saving writes all of the
parameters, including the ones you have changed, to memory in the PCU so they will be
available after POWER has been cycled to the antenna.
2.3.1.
Adjusting Panel Brightness
1.
Press the NEXT key to SELECT this parameter for adjustment.
2.
Once selected, press
▲
&
▼
arrow keys to adjust the backlighting illumination of the
display to desired level. Each keypress steps the value 8 counts.
3.
Then press the SAVE key to save the adjusted setting.
4.
Press the
▼
arrow key to go to the next parameter.
Summary of Contents for Coastal 14
