Sea Tel 9711-92, Installation And Operation Manual

Page: 36 / 196

Installation 9711-92 Ku-Band TXRX
3-14
12. Attach four radome lifting
brackets (PN 122848), or
other lifting arrangement,
evenly spaced around the
bottom of the lower panel
assembly.
13. Insert a 1” bolt through a
fender washer, down through
the bottom flange of one of
the lower panels and thread it
into the threaded lip of the
lifting bracket as shown in the
picture.
14. Attach three more brackets, in
the same manner, so that the
lifting brackets are in four
equidistant points around the
perimeter of the bottom
flange of the lower panel
assembly.
15. Attach web strap lifting sling
to the four points.
16. The lower panel assembly is
now ready to lift onto the
base frame.
3.3.4. Sub-assemble the upper panels of the 144” Radome Assembly
Refer to the Radome Assembly drawing for your system and the procedure below. It is best to have
at least
TWO people sub-assembling the radome, one working from the inside and the other outside. Sub-assemble
the sections of the radome on a clean, flat location that is free of rocks and debris (ie concrete) to assure
good horizontal alignment of the panels.
NOTE: Unless otherwise indicated, all nuts and bolts should be assembled
with Loctite 2760 or its equivalent.
Only 2 people are required to sub-
assemble the top of the radome.
1. On a flat surface, adjoin two
panels and loosely install a
bolt/nut high, mid and low in
the adjoined flange.
2. Continue adjoining additional
panels loosely installing a
bolt/nut high, mid and low on
each flange until all six panels
have been loosely assembled
to form the bottom half of
the radome.