Sea Tel 9711-92, Installation And Operation Manual

Page: 98 / 196

Antenna Specific Operation 9711-92 Ku-Band TXRX
15-2
If any of these steps fail, or the ACU reports model "
xx09
", re-configure the PCU as described in the Maintenance
section of this manual. If initialization still fails, this indicates a drive or sensor problem.
15.3. Reflector A / Reflector B Selection
This antenna should always be set to Reflector
A
. Do NOT use Reflector
B
setting.
15.4. Tracking / Band Selection
In the Status – Tracking menu, you can turn
Tracking
ON/OFF and choose the desired
Band Selection
from the list
generated from the TDISP parameter setting.
15.5. Manually Targeting A Different Satellite
If you are not using OpenAMIP™ to control the ACU, or some other method of remotely accessing the ACU, the
operator will have to manually change settings and parameters in the ACU to target a different satellite than you have
been previously been using. Modem settings will also have to be changed, but are not addressed here.
If, you have remote access into the ACU (or by a series of remote commands).
When multiple settings and parameters must be checked/changed refer to the following flowchart.