Sea Tel 9711-92, Installation And Operation Manual

Page: 60 / 196

Basic Setup of the ACU 9711-92 Ku-Band TXRX
4-2
AZ LIMIT 1 0
Setup – Blockage & RF Radiation
Hazard Zones
AZ LIMIT 2 0
EL LIMIT 12 0
AZ LIMIT 3 0
AZ LIMIT 4 0
EL LIMIT 34 0
AZ LIMIT 5 0
AZ LIMIT 6 0
EL LIMIT 56 0
5v OFFSET 0 Leave at factory Defaults
5V SCALE 0
TX POLARITY 2
TRACK DISP 130 Refer to TRACK DISP parameter
* This parameter value is for use with iDirect 5000 Series satellite modem to provide
Modem Lock input & Modem TX Mute functions. Refer to Setup – Modem Connect,
Setup and Test for values for some other common Satellite Modems and other SYSTEM
TYPE parameter information.
REMOTE PARAMETER Ku-Band Optimize using Lesson
PCU Configuration Number N0xxx 215 Leave at factory Defaults
Home Flag Offset N6xxx 000 Setup – Home Flag Offset
DishScan Phase/Gain N7xxx 193 Leave at factory Defaults
4.4. TRACK DISP
This parameter set the selections that the user will see in the Tracking - Band Selection menu. Band Selection
must
be
set to the appropriate selection for Tracking to operate properly.
The Band selection controls the
local
logic output state of SW1 output terminal on the Terminal Mounting Strip PCB,
the LNB voltage supplied by the pedestal modem, and the
remote
Aux Status (Co-Pol/Cross-Pol receive IF Coax
switch) on the antenna pedestal.
The factory default selections and SW1 status for your antenna is listed in the following table:
TRACK
DISP
Setting
Displayed band
selection
ADE Band Select Parameters
(Tone, Voltage & Aux Status) TMS SW1
Status
0130 Xp B1
Xp B2
Xp B3
Xp B4
Cp B1
Cp B2
Cp B3
Cp B4 Tone OFF, Volt 13, Aux 0
Tone ON, Volt 13, Aux 0
Tone OFF, Volt 18, Aux 0
Tone ON, Volt 18, Aux 0
Tone OFF, Volt 13, Aux 1
Tone ON, Volt 13, Aux 1
Tone OFF, Volt 18, Aux 1
Tone ON, Volt 18, Aux 1 Open
Open
Short
Short
Open
Open
Short
Short