Sea Tel 5012-33, Installation Manual

Page: 29 / 104

Installation 5012-33 Installation Manual
3-9
3. To un-restrain the elevation axis of the
antenna, unthread the two hex nuts. Using a
¾” open end wrench, remove the hex nuts
and washer from the stow pin-bolt.
4. Remove the stow pin-bolt from the bracket.
5. Remove the washer from the stow pin-bolt
and thread one of the 2 hex nuts onto the
bolt and tighten.
6. Put one of the washers onto the stow pin-bolt
and insert it into the bracket toward the
elevation driven sprocket.
7. Put the other washer, and then the other hex
nut onto the bolt.