Sea-doo GTI Series, Operator'S Manual

Page: 42 / 180

PRE-RIDE INSPECTION
Information Center (Gauge)
1. Press START/STOP button and in-
stall the tether cord cap on the en-
gine cut-off switch.
2. As the information center cycles
through its self-test function, en-
sure all indications come on.
WARNING
Always attach the tether cord clip
to your PFD or to the wrist (wrist
strap required).
iBR System (All Models Except GTS)
NOTICE
Ensure there is sufficient
space ahead and behind watercraft
to safely carry out the iBR system
test to avoid a collision. Watercraft
will move during test.
1. Remove the moorings securing the
watercraft to the dock.
2. Start the engine and ensure the wa-
tercraft does not move.
3. On the left handlebar, depress the
iBR lever completely in, the wa-
tercraft should move slowly back-
wards.
4. Release the iBR lever, there should
not be any reverse thrust.
WARNING
Always ensure proper iBR system
operation before taking the water-
craft out for a ride.
Variable Trim System (All Models
Except GTS)
With the engine running in forward po-
sition, use the VTS system to move
the jet pump nozzle up and down alter-
nately to check VTS operation. Con-
firm the VTS position indicator move-
ment in the information center.
Also test the VTS preset trim positions
by double clicking the VTS UP/DOWN
button (as applicable to model).
Refer to
OPERATING INSTRUCTIONS
subsection for detailed instructions.
40
_______
SAFETY INFORMATION
________