ScreenBeam 1100 Plus, User Manual, Page: 36 / 107

32
Built-in Display , Mirror Apple TV , and Use As Separate Display .
 Duplicate (Mirror Built-in Display or Mirror Apple TV on macOS)
The Duplicate mode is used to display the same content on both the device's screen and
the HDTV simultaneously.
Note : There may be minor delay between the content displayed on the HDTV screen
compared to the device’s screen. This is due to the current state of wireless display
technology.
 Extend (Use As Separate Display on macOS)
The Extend mode creates a single, extended "screen" between the source device and the
HDTV. When in the Extend mode, dragging windows to the right side of the device's screen
displays those windows on the HDTV, while dragging windows to the left of the HDTV screen
displays them back on the device's screen. This mode allows users to display selected
content on the HDTV, while all other windows remain on the device's screen. When this mode
is first selected, the HDTV displays only the Windows desktop.
 Second Screen Only
The Second Screen Only mode causes the HDTV to be the only display for the device.
You’ll see everything on the connected screen, and your device’s screen will be blank.
IV.2 HDMI Output Behaviors
ScreenBeam 1100 Plus accepts two kinds of input methods: HDMI input and wireless display
connection, and it provides one outputs: HDMI output. Its input and output follow the rules as
discussed below:
IV.2.1 Single Mode
When ScreenBeam 1100 Plus is in Single mode, it’s input and output follow these rules:
 When an HDMI source is the first connection,
 ScreenBeam 1100 Plus will display this HDMI source only.
 ScreenBeam 1100 Plus can be detected on a wireless display capable source.
 A wireless display source can connect to the receiver successfully, but it is not
displayed.
 The successfully connected wireless display source is displayed after the HDMI