Scott Edge Reinforcer, Instruction Manual, Page: 63 / 117

4 Maintenance
4--14
Edge Reinforcer Issue 1
Fig. 4-23. Install Lower Cut Off -- Blades Ready
to Cut
Step: 6. Slip the bottom cut--off assembly on its
shaft. It is necessary to get this assembly
in the correct position so that the cut--off
knives will mesh properly.
Step: 7. This can be done by rotating the upper
assembly until the knife in the upper
assembly is at the point where it would
normally start to cut. Then slide the lower
assembly into place with the knives in
contact with each other (the lower knife
will be behind the upper knife).
Fig. 4-24. Rotate Housing So Blades Start to
Separate
Step: 8. Rotate the housing clockwise so that the
blades start to separate.
Step: 9. Tighten the mounting screws and clamps
on the upper cutter.
Fig. 4-25. Test Blade Positions By Cutting Tape
Step: 10. Test blade installation by holding tape
between cutting blades and rotating the
upper cutter. The tape should be cut
cleanly.