18
CHAPTER 2: INSTALLATION
087-0038 REV L
SCOTT SAFETY
Caution:
When using the sample draw pump, allow sufficient sample time based on
the length of sample tubing you are using. Allow a minimum of 1 second for every foot
of sample tubing and wait for the gas readings to stabilize. Failure to do so could lead
to inaccurate readings.
Installing - Device Powered Down
This section describes how to install the optional pump when the device is powered
down.
1
Connect the pump by inserting, at an angle, the pump's back Tab into the device's
Tab. Rotate the pump forward until the pump sits flush with the device. Tighten the
Thumb Screw into the threaded hole located on the front of the device. See
.
Figure 15
Pump Installation
2
Power on the device and allow it to run through its start-up routine. At this point,
the pump is running.
3
Upon completion of the start-up routine, the pump activates and BLOCK PUMP
displays. To block pump inlet, place a finger over the probe. Once the test is
passed, CLEAR PUMP displays. See
Align Tab
Tighten
Thumb Screw
Summary of Contents for Protege
