SCM Superset 23, Manual

Page: 7 / 145

SUPERSET 23/23E/PLUS
1.5
GENERAL INFORMATION
1.2
Ref.
Mod. Machine model
Matr. Serial number
Ref. Internal reference
Comp. Machine layout number
N Gross weight expressed in Newton
kg Mass expressed in kilograms
Volt Power voltage
~ F Phase number
Hz Power frequency in Hz
Amp. Power absorption in Ampere
1-4 EXPECTED CONDITIONS OF USE AND CONTRAINDICATIONS
This machine must be used only for the cutting of wood and similar materials. By “similar materials” is meant
materials with similar technological and physical features to those of wood and to the mechanism of working and
removal of shavings.
Materials different from those mentioned above, not being similar to wood, must necessarily be excluded. The
user alone shall be responsible for any damage to the machine produced by machining such materials.
DIMENSIONS OF THE PIECES TO BE MACHINED
The maximum dimensions of the machined pieces are: ................................. height 120 mm x width 230 mm
considering that maximum removal size is 10 mm, the maximum dimensions of the pieces to be worked are:
height 140 mm x width 250 mm.
Given the possibility of removals from 10 mm to 0.1 mm, minimum dimensions can be achieved of: machined
piece height 6 mm (10 mm with electronic control positioning) x width 25 mm
with supplementary equipment for narrow pieces, dimensions are: height 6 mm (10 mm with electronic control
positioning) x width 15 mm
The minimum length of the piece with single feed is: ......................................................................... 600 mm
with relative optional equipment: ....................................................................................................... 435 mm.
TOOLS TO BE USED
The machine has been designed to use exclusively tools in conformity with prEN847-1 standards, suitable for
the type of material to be machined.
The relationship between tool diameter and tool height, given equal rotation speed, is indicated on the table at
chapter 4-1
ENVIRONMENT
The machine can operate in the following environmental conditions:
Humidity: 90 % max.
Temperature: +1°C min. +40°C max.
Altitude: 1000 m a.s.l. max. (above this altitude, consult the manufacturer)
The machine can only operate in closed environments.
This machine cannot work in explosive environments.
1-3 MACHINE IDENTIFICATION
The machine can be identified from the indications provided on the metal plate on the side of the bed.