SCM Superset 23, Manual

Page: 54 / 145

HEADS
4.12
SUPERSET 23/23E/PLUS
ad-i4_2 P12
scm
4.2.3 LEFT VERTICAL SPINDLE
To reach the spindle unscrew knobs A and remove cover P.
Tools can be fitted with dimensions min. 100 mm and max. 200 mm
Vertical adjustment
Loosen handles (Q and M fig. 4.8); turn screw (N) clockwise (using the crank provided) to raise the unit.
Read the setting on the numeric display (R). The setting “0” indicates that the tool support table is at the same
height as the worktable.
Fasten handles (M) and (Q).
NOTE: The exact setting is always achieved “moving upwards”. Vertical adjustment shouldalways be made
with the unit turning.
Transverse adjustment with manual device
This adjustment determines the desired “piece width”.
Loosen handle (Q fig. 4.8), turn screw (O) clockwise (using the crank provided) to reduce piece width.
Read the setting on the display (C fig. 4.9)
NOTE: The exact setting is always achieved “in closure”, i.e., towards the piece to be machined(right fence).
Fasten handle (Q fig. 4.8)