SCI Satloc GPSteer, Manual

Page: 23 / 104

Connecting the Hydraulics | Page 17
Part Number: 875-0139-000
1. Install the
GPSteer Valve
Block
To install the GPSteer Valve Block:
1. Find a desirable location in either the engine compartment or
the back of the vehicle to mount the valve block.
2. Use the GPSteer Valve Block to mark the mounting holes.
3. Use a 5/16” drill bit to carefully drill 2 mounting holes.
4. Use a 5/16” Tap to carefully tap the hole threads.
5. Position the GPSteer Valve Block over the mounting holes.
6. Insert 2 sets of 5/16” bolt, flat washer, and lock washer
through the GPSteer Valve Block mounting holes.
Warning!
When determining a mounting location, it is important to
leave enough room for the cable and hose connections. In
addition, select a location that provides easy access to the
needle valve for calibration purposes.
Warning!
If mounting to the frame, only drill through one wall of the
frame - DO NOT drill completely through the frame.
GPSteer Installation Guide.book Page 17 Thursday, June 17, 2004 10:51 AM