31
6
. Remove the hex nut (D) at the end of the Resistance Knob rod
(A1).
7
. Loosen the Resistance Knob (A) to release the square nut (E)
and spring (F) from the square mount (G) on the Frame.
8
. Remove the old Resistance Knob assembly (A) and bushing (H)
from the mount tube (I) on top of the Frame. Discard the old parts.
9
. Installation is the reverse procedure. Carefully turn the new
Resistance Knob (A) clockwise to install it through the threaded
mount washer (J) inside the mount tube (I).
Note:
Hold the square nut (E) and spring (F) so that the spring
touches the washer (J) in the square mount (G) until the
rod is threaded through the square nut.
10
. Install the new hex nut (D) on the end of the Resistance Knob
rod (A1).
11
. Install the new Brake Assembly (B).
12
. Adjust the Resistance Knob (A) as necessary.
13
. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner’s Manual.
A
D
A1
G
I
A
A
F
E
H
A1
J
I
