Replacing Parts
IC Pro and IC Elite Brake Rod and Knob Replacement
Tools Required:
• #2 Phillips or Flat Head Screwdriver
• 10mm Box Wrench or Small Adjustable Wrench
• 7mm Box Wrench or Small Adjustable Wrench
Procedure:
A. Replace the Tension Control Knob
1. Turn the tension control knob to least resistance.
2. Use a flat or phillips head screwdriver to remove the
shrouds. (See Figure 7.)
3. Remove the brake rods from the rod carrier by holding the rod
tightly and lifting up and out of the carrier. (See Figure 8.)
4. Use a wrench to remove the 10mm nut on the end of the tension
control knob.
5. Remove the square nut and rod carrier from the tension control
knob.
6. Remove the tension control knob and replace with the new
longer control knob. (See Figure 9.)
7. Replace the rod carrier, square nut and 10mm nut. Secure
tightly. (See Figure 10.)
B. Replace the Brake Rods
1. Invert the brake rod and use a wrench to remove the 7mm nut on
the end of the rod.
2. Remove the rods, springs, and rubber grommets and replace
with new shorter rods, springs and rubber grommets.
Figure 7
Figure 8
Figure 9
Figure 10
Service Manual
11
Summary of Contents for IC ELITE
Page 13: ......
