14
EASY-MAG-Series | Version 2.01
Set up
8.2 Requirements for the installation site
The device has been designed for use in roofed rooms
and must be set up in a dry environment. The ambient air
in which the welder uses we should have a temperature
of below + 40 ° C and a low humidity. The ambient air
must be free from dust, acids, salts or concentrations of
iron or metal powders. Make sure there is enough space
in front of the device so that the controls can be easily
accessed and viewed. Place the device in such a way
that the air inlet and outlet is not obstructed. Make sure
that no metal parts, Straub or other foreign objects can
penetrate into the device.
8.3 Mains connection
Check the conformity of the voltage indicated on the ra-
ting plate with the rated voltage of your power supply.
The device may only be used with sockets and extension
cables with earthing contact plugs installed by an autho-
rized specialist. The protection of the supply lines to the
power outlets must comply with the regulations. Accor-
ding to these regulations, only fuses or automatic de-
vices corresponding to the cable cross-section may be
used. An overuse may result in a fire or building fire da-
mage. Before plugging in the mains plug, the mains
voltage selector switch must be set to zero.
8.4 Assembly instructions
A
The wheel axle
2
is applied to the bottle holder from
below. Align the axle so that the holes in the bottle
cage align with the holes in the axle. Connect the com-
ponents with the hexagon screws
E
.
B
Insert left and right over the wheel axle
1
. One washer
M8 each.
2
The two plastic wheels
3
and lock washer
are internally toothed.
C
Put the hub cap
5
on the wheel axle 2. Press the caps
firmly.
D
The steerable wheels
4
are screwed by means of
screws
8
and the threaded bushes on the underbody
of the machine.
NOTE!
The environmental conditions must be adequate to
the degree of protection IP21!
DANGER! ELECTRICAL VOLTAGE
Do not use the device outdoors in the rain!
DANGER! ELECTRICAL VOLTAGE
Connection to the mains and maintenance must be
carried out according to VDE regulations!
Defective or damaged parts on the burner or hose
package must be replaced immediately!
Summary of Contents for EASY-MAG 171
Page 30: ...www schweißkraft de ...
