Schwank 40660000, Technical Manual

Page: 13 / 71

Revision: 3.0 Page 12 of 71
Figure 8: Temperature and humidity
In addition to the operating mode, select the desired time program for the zone. This program is only used in
automatic mode.
When using automatic mode, a time program must be assigned in advance. To do this, select the "No time
program assigned" field and create a separate time program. The creation of time programs is described in
section 5.4.1.
All programmed holiday periods apply to the entire control unit, but to only those zones in automatic mode
that take holiday periods into account. Setting holiday periods is described in section 5.4.2.
5.3.2. Temperature and humidity setpoints
The setpoints for temperature and humidity
can be edited by selecting the colour-
highlighted pencil. The following screen
appears:
If the measured humidity is higher than the pre-set value, the heating request remains active, even after the
setpoint temperature has been reached, to reduce the humidity / until the setpoint value has been reached.
It is also possible to switch off the humidity control.
The manual mode setting is given in percent and refers to the output value of the control output.