SCHUNK TANDEM KSP3, Assembly And Operating Manual

Page: 35 / 52

Maintenance and care
Assembly Assembly is done in the reverse order of disassembly. In doing so,
observe the following.
• Pay attention to the mounting position of the base jaws (item 2)
and the chuck piston (item 3).
• Observe the tightening torques for the screws
}
4 [
/
17] .
• After completion of the assembly, carry out a leak test and a
function test. } 7.4.3 [
/
37]
• For variants with clamping force maintenance (AS), mount the
cylinder piston using an assembly device Assembly
devices
} 7.4.4 [
/
37]
• Variant "PM": Pay attention to the correct alignment of the
monitoring pieces! Readjust the pneumatic jaw end position
control before mounting the guide rails (6).
Adjustment of pneumatic jaw end position monitoring
Jaw 1: monitoring open jaw position
• Move base jaws to OPEN position.
• Screw the set-screw (61) into the bore hole o up to the stop and
then unscrew it again by a few turns.
• Slowly screw the set-screw (61) into the bore hole oo until the
differential pressure sensor emits a switching signal.
• Hand-tighten set-screw (61) in bore hole o.
• Screw set-screw (63) in both bore holes and hand-tighten.
Jaw 2: monitoring closed jaw position
• Move base jaws to CLOSED position.
• Screw the set-screw (61) into the bore hole oo up to the stop
and then unscrew it again by a few turns.
• Slowly screw the set-screw (61) into the bore hole o until the
differential pressure sensor emits a switching signal.
• Hand-tighten set-screw (61) in bore hole oo.
• Screw set-screw (63) in both bore holes and hand-tighten.
35 04.00 | KSP3, KSP3-LH, KSP3-F | TANDEM Clamping Block | en | 1463318