SCHUNK ROTA-S flex, Assembly And Operating Manual

Page: 7 / 40

Basic safety instructions
2 Basic safety instructions
Improper handling, assembly and maintenance of this product
may result in risks to persons and equipment if this operating
manual is not observed.
Report any failures and damage immediately and repair without
delay to keep the extent of the damage to a minimum and prevent
compromising the safety of the product.
Only original SCHUNK spare parts may be used.
2.1 Intended use
The chuck is used to clamp workpieces on machine tools and other
suitable technical facilities, paying particular attention to the
technical data specified by the manufacturer. The technical data
specified by the manufacturer must never be exceeded.
The product is intended for industrial use.
Intended use also means that the user has read and understood
this operating manual in its entirety, especially the chapter “Basic
safety notes”.
The maximum RPM of the chuck and the required clamping force
must be determined by the user for the respective clamping task
based on the applicable standards and technical specifications of
the manufacturer.
(See also “Calculations for clamping force and RPM” in the chapter
“Technical data”).
}
6.1 [
/
18]
2.2 Not intended use
A not intended use of the product is for example:
• It is used as a press, a punch, a toolholder, a load-handling
device or as lifting equipment.
• the product is used for unintended machines or workpieces.
• the technical data is exceeded when using the
product.
}
6.1 [
/
18]
• if workpieces are not clamped properly, paying particular
attention to the clamping forces specified by the manufacturer.
• if it is used in working environments that are not permissible.
• if the product is operated without a protective cover.
2.3 Notes on particular risks
This product may pose a danger to persons and property if, for
example:
• It is not used as intended;
• It is not installed or maintained properly;
7 06.00 | ROTA-S flex | Assembly and Operating Manual | en | 0889139