Technical data
18
06.00 | ROTA-S flex | Assembly and Operating Manual | en | 0889139
6 Technical data
6.1 Chuck data
(with long base jaws)
ROTA-S flex
550
700
1000
1200
1400
Max. torque
Nm
120
220
280
320
350
Stroke per jaw
mm
7
9.7
12
12
15
Recommended max. speed
min
-1
1000
800
500
500
400
Total gripping force max.
kN
100
180
230
270
270
Mass moment of inertia
kg m
2
1.6
7.078
25.03
57.89
125.28
Chuck through hole
mm
52
92
102
162
252
Weight with jaws
kg
65
150
360
490
830
Centrifugal torque of the long
base jaws
M
cGB
kgm 0.153
0.5448
1.8
2.66
5.59
Max. jaw center eccentricity in
axial direction (with long base
jaws)
a
max
mm
For the ROTA-S flex chucks it's necessary to
determine those data specific. Calculation
examples are in the chapter "Technology" in
the SCHUNK-lathe-chuck-catalog or in the
chapter "Special jaws/Technology" in the
SCHUNK-power-chuck-catalog. Those catalogs
are also available as download at
www.de.schunk.com.
The recommended max. speed is only valid for max. operating
force and the use of the suitable hard standard stepped jaws.
Warranty and maximum clamping cycles
Length of warranty
24 Months
Maximum clamping cycle number
50 000 Cycles
When using unhardened top jaws or jaws in special design, make
sure that their weight is as low as possible
For soft top jaws or jaws in special design the permissible speed of
the respective cutting task has to be calculated in accordance to
VDI 3106, whereby the maximum standard value may not be
exceeded. The calculated values have to be examined with a
dynamic measurement. Control of function (piston movement and
actuation pressure) has to be accomplished in accordance with the
guidelines of the professional association.
The recommended speed is valid for ROTA-S flex with long base
jaws and SCHUNK stepped block jaws, hard, type STF.
In this the base jaws are inserted flush with outer diameter of the
chuck.