SCHUNK PGB, Assembly And Operating Manual

Page: 44 / 52

Maintenance
44 13.00 | PGB | Assembly and Operating Manual | en | 389275
6.6 Assembling the module
Position of the item numbers } 6.8 [
/
45]
Unless otherwise specified, secure all screws and nuts with Loctite
no. 243 and tighten with the appropriate tightening
torque.
} 6.7 [
/
44]
1. Push the base jaws (2) into the housing (2).
When doing this, pay attention to the correct installation
position.
2. Insert the piston (3) into the housing (1) from above. Position
the base jaws (2) so that the piston (3) can be pushed into the
base jaws (2) with no problem.
3. Push the cylinder piston (6) into the housing (1) from below.
- Observe the correct assembly position.
- Pay attention that the sealing lips of the seal (30) are not
damaged.
4. Mount the lock nut (13).
5. Screw the cover (4) on tight with the screws (41).
6. Screw the cover plate (5) on tight with the screws (47).
6.7 Tightening torques for screws
Position of the item numbers } 6.8 [
/
45]
Item
Size
64 80 100 125
13 8 Nm 10 Nm 12 Nm 20 Nm
41 1.3 Nm 3.1 Nm 3.1 Nm 7.1 Nm
42 - 0.3 Nm 0.3 Nm 1.3 Nm
43 - 0.3 Nm 0.3 Nm 1.3 Nm
44 - 1.3 Nm 1.3 Nm 1.3 Nm
47 0.5 Nm 0.5 Nm 0.5 Nm 0.5 Nm