SCHUNK GSW-M 20, Assembly And Operating Manual

Page: 18 / 24

Maintenance
18
02.00 | GSW-M | Assembly and Operating Manual | en | 389114
7 Maintenance
7.1 Notes
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
7.2 Maintenance intervals
NOTICE
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
•
Reduce the lubricant intervals accordingly.
Interval
(million cycles)
Maintenance work
periodically visual inspection of the friction ring ( (11).
when required clean magnetic surface.
2 Clean all parts thoroughly, check for damage and
wear, if necessary replace seals and wearing parts
Disassembly and assembly [ } 19].
The seals are in the enclosed sealing kit. Seal
kit [ } 6]
2 Treat all grease areas with lubricant Lubricants/
Lubrication points [ } 18].
Oil or grease bare outside steel parts.
7.3 Lubricants/Lubrication points
SCHUNK recommends the lubricants listed.
During maintenance, treat all greased areas with lubricant. Thinly
apply lubricant with a lint-free cloth.
Lubricant point Lubricant
Metallic sliding surfaces microGLEIT GP 360
All seals Renolit HLT 2
Bore hole at the piston Renolit HLT 2