Schulze Big-O-Lite pneu plus, Instruction Manual

Page: 9 / 18

The display shows:
Energy-saving-mode.
11. With the buttons + and – you can switch the energy-saving-mode on/off.
12. Press button 1.
The display shows: Overall counter .
Here you can see the number of all pressing activations.
13. Press button 1.
The display shows: Hours of work.
Here you can see the number of hours the press has worked.
14. press button 1.
The display shows: Diagnostic function .
Here you can check the electric circuits: - temperature fuse
- thermo couple
- power relay
15. To end the programming mode, press button 1.
3.2 Resetting of the electronic devices
Attention!
You only should reset the heat press after getting in contact with the producer.
To reset the heat press, press button 1 and 2 at the same time. Button 1 should be pressed 1
second earlier. Hold the buttons 20 sec.
Confirm the action with button 2 or cancel it with button 3. If you press the button YES the
Temperature will change to the original setting.
3.3 Error reports
The electronic devices of the Big-O-Lite pneu control the main functions of the press.
Here is a list of possible messages:
ERR.1 – No connection of the electronic devices to the temperature sensor. ( Temperature sensor defect/ cable not connected)
ERR.2 – Connection of electronic devices and temperature sensor bypassed. ( Temperature sensor defect/ )
ERR.3 – Resistor of temperature sensor too low. The temperature range of the electronic devices is deceeded.
ERR.4 – Resistor of temperature sensor too high. The temperature range of the electronic devices exceeded.
ERR.5 – No temperature rise within 3 minutes even if heating element is switched on. (
Temperature fuse is defect )
ERR.6 – No reduction of the temperature within 3 minutes even if heating element is turned off. (Power relay CRYDOM is defect)
ERR.7 – Temperature too high, over 230°C (Power relay CRYDOM is defect)
ERR.3 and ERR.4 can occur if the electronic devices are not programmed properly.
Version 16.01 9 / 18