Schulte SRW1000, Operator'S Manual

Page: 54 / 94

OPERATION
SRW1000 08/17 Operation Section 4-10
© 2017 Alamo Group Inc.
OPERA
T
ION
6.3 Connecting Windrower Hydraulic Lines to the Tractor
With the tractor shut down and secured in position,
relieve hydraulic pressure from the tractor by
moving the control levers back and forth several
times or placing the levers in the float position.
Keep implement hydraulic lines, hoses, quick
couplers, and swivels free of contamination. Never
leave a disconnected hose end open and cap the
tractor hydraulic outlet ports when not in use. If the
tractor ports, SRW1000 ports and hydraulic hose
ends become contaminated, wipe clean with a rag
before connecting.
Hydraulic Cylinder Priming
Hydraulic Cylinder must be filled with hydraulic oil before operating the windrower in a certain angle. Hydraulic
cylinders and lines are filled by holding the valve control levers in the extended position until the cylinder fully
retracts and extends. Place control levers in the float position and repeat process several more times to purge
all air from the system.
6.2 Safety Tow Chain
If the implement is towed on a public roadway, a safety chain with tensile strength equal to or greater than the
gross weight of the implement must be connected between the tractor and implement. This will help control
the implement in the event the tongue becomes disconnected from the drawbar. Make sure the chain is
attached to a secure location on the tractor and not to an intermediate support.
After connecting both ends of the safety chain, drive the tractor to the right and left to check for proper chain
length. Adjust length as necessary and allow only enough slack in the chain to make a maximum turn in both
directions. When not in use, store the safety chain to protect it from mud or standing water by wrapping the
chain around the tongue. Replace the safety chain if one ore more links or end fittings are broken, stretched or
otherwise damaged or deformed.
OPS-W-0014
Do not operate this Equipment with hydraulic oil or fuel leaking. Oil
and fuel are explosive and their presence could present a hazard. Do
not check for leaks with your hand! High-pressure oil streams from
breaks in the line could penetrate the skin and cause tissue damage
including gangrene. To check for a hose leak, SHUT the unit ENGINE
OFF and remove all hydraulic pressure. Wear oil impenetrable gloves,
safety glasses and use cardboard to check for evidence of oil leaks. If
you suspect a leak, REMOVE the HOSE and have it tested at a Dealer.
If oil does penetrate the skin, have the injury treated immediately by a
physician knowledgeable and skilled in this procedure.
(SG-15)