Bedienungsanleitung/Operating Instructions
schuett phoenix II Sicherheits-Bunsenbrenner/Safety Bunsen Burner
Seite/page 16
Features (phoenix II eco)
Operating mode “Hand”
Activate the flame by shortly pressing the centre of the joystick.
The flame is burning until it is stopped by pressing the joystick again.
For your own safety, the maximum-burn time has been preset to 15 minutes by the manufacturer.
This setting may be increased up to 120 minutes.
At the bottom of the burner, there is a long hole under which a rotary encoder switch is situated.
Move this switch by using a small screw driver in order to adjust the desired maximum burn-time:
0 = 15 min; 1 = 30 min; 2 = 60 min; 3 = 80 min; 4 = 120 min
5 = 15 min; 6 = 30 min; 7 = 60 min; 8 = 80 min; 9 = 120 min
Operating mode “Foot-switch” (connection, see Putting into operation (page 10)
Activate the flame by shortly pressing the foot-switch. The burner is only activated as long as the
foot-switch is pressed.
Indicator lamp “Power”
Red =
Burner is ON
, normal operation.
Flashing red/yellow
=
Warnings
- Please check the burner.
For safety reasons the burner may not be re-activated while this remark
is shown.
.
1.
Clean burner head:
If the flame stops due to e.g. spilled liquids and
the burner may not be re-ignited, the gas supply is automatically and
permanently shut. The burner head is soiled. Clean the burner head (see
“cleaning the burner head”, page 30) and confirm the setting by shortly
pressing the centre of the joystick.
2.
Check gas supply:
In case during automatic (re-)ignition the burner
may not produce a flame after 10 seconds, the schuett phoenix II eco
automatically shuts the gas supply. Please check the gas supply and
confirm the setting by shortly pressing the centre of the joystick.
3.
Burner overheated:
The schuett phoenix II is suitable for continuous
operation (120 min) and may not overheat. However, if the burner gets
too hot due to inappropriate conditions such as back reflections of heat
or unfavourable setting of flame (gas and air supply), the device
automatically switches off the flame and shuts the gas supply. Wait
until the burner has cooled down, the device automatically returns to
the normal operating mode.
Flashing red
=
Hot burner head –
Caution: Risk of burns!
After switching the schuett phoenix II eco off, the indicator lamp
flashes as long as the burner head is hot. As soon as the burner head has
cooled down, the flashing stops automatically.
