Schleuniger ACO 08, Operating Manual

Page: 26 / 52

General handling / operation
26 | 52 Operating Manual | Edition 1.00 (08-2020) | ACO 08
Specified fault limit exceeded. If configured in
the setup, the error must be acknowledged on
user level 1 by entering the password.
Acknowledgment without password is possible
on user level 2 or 3.
7.2.3 Teaching
Before the monitoring status can be started, a reference curve must be formed from one or several
good crimps. The number of reference crimps is defined in setup.
1.
To access the teaching mode, select the
“teaching” tile on the main menu (possibly
requires user level 2 or 3 if configured in
setup).
2. Produce a reference crimp on the crimping
machine and use it to verify the quality
criteria (e.g. crimp height, pull-off
strength/cross section) and confirm with
“OK” if prompted.
If the crimp does not meet the quality
criteria, use “discard” to reject it.
3. If a curve deviates too much from the
previous curves, the message “invalid Ref”
appears automatically. Select “OK” to
generate the last curve again or “discard”
to start over with teaching.