Schindelhauer Bikes Frieda, Manual

Page: 34 / 64

34
EN
Adjusting the belt tension Removing the tooth belt
1. Remove the stainless steel cover (TORX 8 / fig. 12).
2. Loosen the two M8 bolts on both sides (0.5 -1 revolutions) until the
sledge can freely move (fig. 13).
3. Use a 2.5 mm hex key to rotate the turnbuckle clockwise in order to
move the sledges backward. This will increase the tension of the belt
(fig. 14). Make sure to adjust both sledges evenly, so that the wheel is
centered between the seat- and chainstays.
4. To decrease belt tension turn counter-clockwise. To increase belt
tension turn clockwise.
5. Check the belt tension (page 33).
6. Tighten the two M8 bolts on both sides with the torque stated in the
chart (page 42) and assemble the stainless steel cover.
1. Remove the rear wheel (page 31).
2. Remove the stainless steel cover. For this, remove the two countersunk
bolts M2.5x8 with TORX 8 (fig. 12).
3. Remove the drop out sledges by loosening the M8 bolts with a TORX-40
(fig. 15).
4. Remove the bolt M6x55 which you can find at the bottom side of the
drop out (fig. 16).
5. Remove the frame key.
6. Remove the belt through the gap at the drop out (fig. 17).
7. The assembling is in reverse order. Make sure that after assembling the
belt is in the required track. The belt must not run entangled.
13 12