12
Tecnoflex Plus Accessories
Pot Hanger
Combined Pot Hanger
& Terminal
Top Clamp
Terminal
COMBINED POT HANGER & TERMINAL
The combined pot hanger and terminal supports the weight
of up to 15m of TecnoFlex Plus using the existing chimney
pot as an anchor point. The flex is pulled down the existing
chimney stack using the nose cone (see p.13). Once the flex is
in position at the base of the stack, with the single wall to flex
adaptor fitted in place through the closure plate, at the top
of the chimney, the flex protruding through the chimney pot
should be cut off level with the top of the pot. The threaded
adaptor on the bottom of the terminal is then screwed onto
the outside of the TecnoFlex Plus liner (see Fig.1) until the
storm collar rests on the top of the chimney pot. The three
straps which are welded to the underside of the collar, are
located to the outside of the pot (see Fig.2 opposite). The
fixing strap in the kit is then fastened over these three straps,
leaving approximately 50mm protruding below. The fixing strap
is tightened into place using a screwdriver. The protruding
ends on the three straps are then bent upwards into a loop
around the fixing strap (see Fig.3).
POT HANGER
The pot hanger is installed in the same way as the combined
pot hanger and terminal (See Fig.1,2 & 4 opposite).
TERMINAL
The screw fit terminal is used in combination with the plate
and clamp (see Fig.6 opposite). The adaptor on the bottom
of the terminal is screwed on to the flex (see Fig.1). Cement
flaunching is then used up to and around the base of the
terminal to make the system weather tight.
TOP CLAMP
The top clamp is used in combination with the top plate to
support the weight of the liner at the top of the stack. The
split band passes around the TecnoFlex Plus liner and is then
tightened in place using the nuts and bolts provided. The band
then rests on top of the top plate (see Fig.5 opposite). The top
clamp will support the weight of up to 20m of TecnoFlex Plus.
