english 11
Longitudinal stop Fig.10
To control long work pieces, a longitudinal stopper (9)
can be used.
m
Electrical Connection
The installed electric motor is connected and is ready
to work.
The connection complies with the relevant VDE and DIN
regulations.
The customer-side network connection and the used ex-
tension line must comply with these provisions.
Installations, repair, and maintenance work relating to
the electric installation may only be performed by spe-
cialists.
Important notes
The electric motor is designed for operating mode S 1.
If the motor is overload it is turned off automatically.
After a (varying) cooling period the motor can be turned
on again.
m
Maintenance
Slightly lubricate the work table before working. This fa-
cilitates the final cleaning of the work table.
Warning:
Exclusively use original spare parts for the main-
tenance/service.
Disconnect the mains plug prior to each intervention in
the grinding machine.
General maintenance notes
The grinding machine must be cleaned carefully after
each deployment. Regularly lubricate all moveable parts.
Treat the work table with a thin layer of automotive type
paste wax. This facilitates the cleaning of the work ta-
ble.
EC Declaration of Conformity
We herewith declare, scheppach Fabrikation von
Holzbearbeitungsmaschinen GmbH, Günzburger Str. 69,
D-89335 Ichenhausen that the machine described below
due to its con struc tion and design and in the version
delivered by us complies with the relevant provisions of
the following EC Directives.
In case of a modification of the machine this declara tion
ceases to be valid.
Machine description:
Edge grinding machine
Machine type:
ksm 2500, Art. Nr. 8107 0101, 8107 0102
Relevant EC directives:
EC machine directive 98/37/EG (< 28.12.2009),
EC machine directive 2006/42/EG (> 29.12.2009),
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Applied harmonized European standards
EN
12100-1,
EN
12100-2,
EN
13857,
EN349,
EN418,
EN847-1,
EN
13849-1,
EN1088, EN50082-1, EN60204-1, EN55014, EN60555-2,
EN60555-3, EN61029-1, EN61029-2-5
Notified body within the meaning of Annex VII
TÜV Rheinland, Product Safety GmbH, 51101 Köln
Engaged for:
EC design certification AM 500428140001,
AM 500428170001
Place, date:
Ichenhausen, 22.07.2009
Signature:
On behalf of Wolfgang Windrich (technical director)
Trouble shooting
Problem
Possible Cause
Help
Motor does not start
a
)
ON/OFF switch damaged.
b
)
ON/OFF cable damaged.
c
)
ON/OFF relay damaged.
d
)
Fuse burnt-out.
e
)
Motor burnt-out.
a-d
)
Replace all damaged parts before you
use the grinding machine.
e
)
Contact your local service centre or an
authorized service station. Each at-
tempted repair may cause dangers if not
performed by a qualified expert.
Machine gets slower
during the work
An excessive pressure is exerted on the work
piece.
Exert less pressure on the work piece.
Grinding belt runs off the
drive wheels.
It does not run in the track.
Readjust the track.
Wood burns during the
grinding operation.
a
)
Sanding disc or belt covered with grease.
b
)
An excessive pressure is exerted on the work
piece.
a
)
Replace the belt or the disk.
b
)
Reduce the pressure on the work piece.
