www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
20 | GB
By properly disposing of this product, you are also
contributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Spare-part ordering
Please quote the following in your order for spare
parts:
• Type of device
• Article No. of device
• Ident. No. of device
• Spare Part No. of the required spare part
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Cylinder, piston, piston rings
* Not necessarily included in the scope of delivery!
12. Troubleshooting
Fault
Possible cause
Remedy
The compressor does
not start.
No supply voltage.
Check the supply voltage, the power plug and the
socket-outlet.
Insufficient supply voltage.
Make sure that the extension cable is not too long.
Use an extension cable with large enough wires.
Outside temperature is too low.
Never operate with an outside temperature of be-
low +5° C.
Motor is overheated.
Allow the motor to cool down. If necessary, rem-
edy the cause of the overheating.
The compressor starts
but there is no pres-
sure.
The non-return valve leaks.
Have a service center replace the non-return
valve.
The seals are damaged.
Check the seals and have any damaged seals re-
placed by a service center.
The drain plug for condensation water (8)
leaks.
Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
The compressor
starts, pressure is
shown on the pressure
gauge, but the tools
do not start.
The hose connections have a leak.
Check the compressed air hose and tools and re-
place if necessary.
A quick-lock coupling has a leak.
Check the quick-lock coupling and replace if nec-
essary.
Insufficient pressure set on the pressure
regulator (3).
Increase the set pressure with the pressure regu-
lator.
11. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste electri-
cal and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment.
Summary of Contents for 59061129933
Page 30: ...www scheppach com service scheppach com 49 08223 4002 99 49 08223 4002 58 30...
Page 31: ...www scheppach com service scheppach com 49 08223 4002 99 49 08223 4002 58 31...
Page 33: ...www scheppach com service scheppach com 49 08223 4002 99 49 08223 4002 58 33...
Page 35: ...www scheppach com service scheppach com 49 08223 4002 99 49 08223 4002 58 35...
