6
NOTICE:
Check the installation situation of the relevant vehicle type.
Installation position:
The heater must be installed in as low a position as possible to allow the heater and circulating pump to be bled
automatically. This is particularly important as the circulating pump is not self-priming.
The heater may also be installed in a box. The installation box must have sufficient external ventilation to ensure
that a maximum temperature of 85 °C (185 °F) is not exceeded inside the box.
Keep in mind the space required for servicing accessibility (for instance for removing the combustion chamber)..
first start-up
NOTICE:
Cancelation of all warranty and liability claims!
Not following the required installation conditions will lead to the loss of all warranty and liability claims!
Installation must comply with governing statutory regulations listed on
page 4.
If the water heater is to be operated in a separately installed heating system, prior to installation an installation
planning report must always be submitted to SCHEER for approval. If this approval is not obtained, all warranty and
liability claims will be void.
DANGER: Death or serious injury due to improper installation or repair.
Improper installation or improper repair can cause a fire or the leakage of deadly carbon monoxide leading
to serious injury or death.
The person to install and repair the heating system must have completed a SCHEER training course.
Always follow all installation and repair instruction.
Heed all warning and safety signs.
All required technical documentations, tools, and equipment must be available in the vehicle for installation and
repair.
NOTICE:
SCHEER rejects any liability for defects and damage, which are due to installation or repair by unauthorized
and untrained persons.
Refer to the safety instructions in the operating and maintenance manual!
Read and understand all operating and maintenance instructions before starting the heater.
After installing the heater bleed the water system and the fuel supply system carefully. Follow the instructions supplied
by the vehicle manufacturer for this purpose.
Check the electrical connections for the correct polarity.
Conduct a test run of the heater to check all the water and fuel connections for leaks and ensure that they are tight and
secure. In case of an error during the test run or normal operation refer to the trouble-shooting table and fix it.
Tighten all pipe union connections after the first full heat up operation. Please send a copy of the start-up protocol to
SCHEER.
Installation
The model and identification plate must be protected from damage and must
be clearly visible when the heater is installed (otherwise a dublicate model and
identification plate must be used)
Fig. identifidation plate example
Made in Germany
HEIZGERÄT Typ:
MH 10/17
Spannung / EL Leistung
230V / 250W
Wärmestrom max.
17 kW
Brennstoff
Diesel / Heizöl
zul. Betreibsüberdruck
3 bar
Artikel. Nr. Ausf.
Fabr. Nr.
Inbetriebnahmejahr 2021
E1 122R-000517
E1 ECE-R10-058096
iden
tifida
tion pla
te e
xample
E
1
E
1
identification plate
Summary of Contents for 077480
Page 31: ......
