20
Situation: 18.07.2005
SDT-0018-02EN
Instruction Manual Control and Switch Panel DT 201 B
7
Maintenance
The control and switch panel requires no maintenance.
Cleaning
Clean the front plate of the control and switch panel with a soft, slightly damp
cloth and a mild detergent.
Never use spirit, thinners or similar substances.
Do not allow any fluid to penetrate the inside of the control and switch panel.
8
Shutting down
Switch off the system if you are not going to use the motorhome for a lengthy
period (for example during the winter).
Shutting down the system
for up to 6 months
Fully charge up the living area battery before shutting down the system. The
living area battery is then protected against total discharge. This applies only
if the battery is intact. Follow the instructions of the battery manufacturer.
Carry out the following work steps in the correct order:
1. Switch off the 12 V main switch on the control and switch panel.
2. Turn off the battery cut-off switch on the Electrobloc.
Shutting down the system
for more than 6 months
Fully charge up the living area battery and remove the connecting terminals
on the battery poles. Carry out the following work steps in the sequence men-
tioned below. The battery alarm is then no longer active.
Disconnecting the living
area battery from the 12 V
power supply
Carry out the following work steps in the correct order:
1. Switch off the 12 V main switch on the control and switch panel.
2. Turn off the battery cut-off switch on the Electrobloc.
3. Remove the clamps from the battery poles.
W
Before using the battery cut-off switch on the Elektrobloc or before discon-
necting the living area battery from the 12 V power supply, the 12 V power
supply must be switched off with the 12 V main switch on the control and
switch panel!
W
For other shutdown tasks, see the instruction manual for the Electrobloc.
