2019/10/07
Operating manual/BEAROMOS 2020/Version 1.0
Page 9 of 26
2.3
Risk and safety declarations
For welding work on the motor, the sensor must be disconnected from the power supply.
Components of the sensor can become hot. Make sure they have cooled sufficiently before carrying
out maintenance and repair work. Wear heat-insulating gloves if necessary.
WARNING! Risk of being drawn into the device during installation
You may only install the device with the motor switched off. The device may only be
commissioned once all components have been completely installed.
There is a risk of crushing when installing the sensor
The sensor may only be installed by qualified persons. Wear protective gloves if necessary.
The sensor must be aligned correctly, otherwise the sensor shaft may be damaged, which may then
damage the motor as a result. The supplied centring pin must be used for this purpose.
The sensor must be installed by a qualified person. It must be aligned centrally.
WARNING! Risk of being drawn in by rotating parts (shaft).
If disassembled while being operated, parts may be ejected outwards.
The cover may only be removed with the motor switched off.
There may be a risk of slipping, tripping and falling in the working environment.
Depending on the working environment, additional measures may have to be taken to minimise or
eliminate the risk of slipping, tripping or falling.
Hazard from external noise - the sensor does not emit any significant noise.
If necessary, wear appropriate PPE if there is noise in the environment (hearing protection).
