2019/10/07
Operating manual/BEAROMOS 2020/Version 1.0
Page 14 of 26
2.
Screw the hexagon nut onto the adjusting adapter
3.
The adjusting adapter is screwed into the adapter for the crankshaft until the adjusting
adapter is
flush with the stand plate. To help you during installation, we recommend using
an angle to
check the alignment as well.
4.
Tighten the hexagon nut.
Figure 6: Shaft adapter alignment
4.3.2
Installing the BEAROMOS 2020:
1.
Before installing, remove the orange cover using the four Allen screws and remove the
transport lock (black plastic pin) from the sensor shaft.
2.
Insert the centring pin and fasten it with the enclosed bolts
Figure 7: Alignment and installation - Part 1
